It is now possible to have more than one single Smart Dimension selected at once and edit the properties of those dimensions simultaneously through the Property Browser. Multi-select Dimensions for Quick Editing in the Property Browser Click and drag the dimension to the new location, click again to place. While in the Dimension command and after you have placed your dimension, Left-click on the highlighted red Dimension Arrow (line end) or the Dimension Text to “enter edit mode”. Move Dimension After Creation While Within the Dimension Command When selecting and moving many sheet curves in the IronCAD Drawing Environment, the performance has been improved on the grouped and ungrouped curves during the drag and move behaviors. Improvements on Move Performance of Many Sheet Curves This option can be found on the View Properties page. Now you can set desired views that will only export when using the Export to DWG/DXF command. For example, when working on large drawings for laser cutting, you may want to exclude certain views from the export process. In many cases, you may want the ability to have more control with DWG/DXF exporting. In the dimension command, you can select the “Spacebar” to provide snap settings to End Points, Centerpoint’s, Quadrants, Mid-Points, and Edges.
![ironcad large assembly mode ironcad large assembly mode](https://www.ironcad.com/WhatsNewArchive/IRONCADV11/Images_to_be_localized_Dialogs_and_Toolbars/TextJustification.gif)
When dimensioning, especially on a small area or zoomed-out areas, it is sometimes difficult to select the desired entity point. The rotation point for TextBoxes has been changed to default to the center of the box, making it easier to perform a rotation. Rotation Point of Text in Properties Default at Center As usual, the left mouse button will not give you those options and simply rotate. Hold down the right mouse button, to rotate and then release to get an option to set an exact angle value. Simply press the hotkey “G” to magnify the area around the current cursor location that will allow precise highlight and selection on the zoomed-in area.Ī new option has been added under the right-click menu of TextBoxes. Magnify Glass Support for Annotating Smaller AreasĪ new magnifying glass behavior has been added to the IronCAD Drawing Environment to improve the ability to annotate smaller areas of the drawing views that would normally require zoom in/out processes. This new capability can be found on the Sheet Setup in the IronCAD Drawing Environment. New ability to associate properties to the sheet name in ICD is now available to automatically define sheet names based on the content in the drawing. Link Sheet Label to Scene/Document Properties
![ironcad large assembly mode ironcad large assembly mode](https://venturebeat.com/wp-content/uploads/2018/04/screen-shot-2018-04-16-at-2-27-53-pm.jpg)
![ironcad large assembly mode ironcad large assembly mode](https://pbs.twimg.com/media/FBBkaFuVgBgk3pJ.png)
This is a useful capability to quickly apply dimension on views along with the other options already supported in the Bulk View Creation Process.īox Select Creation of Ordinate Dimensionsĭuring the Ordinate Dimension command, you can now box select areas to place ordinate dimensions to speed up the detailing process. The Auto Dimension tool can be set on a per-view basis in templates used for the Bulk View Creation to automatically create dimensions when creating drawings. Simply press the ESC Key in these process dialogs to exit out of the process.Īuto Dimension Support for Bulk View Creation Template With the introduction of the Progress Bar, it is now also possible to cancel many operations where you previously had to wait until it was finished. Press to Exit View Creation or Other Long Process Commands